H3C Technologies H3C S3600 Series Switches - Manual (Page 324)

3-9
Configuring split horizon
Follow these steps to configure split horizon:
To do... Use the command... Remarks
Enter system view system-view —
Enter interface view interface interface-type interface-number —
Enable split horizon rip split-horizon
Required
Enabled by default
Split horizon cannot be disabled on a point-to-point link.
Configuring RIP-1 packet zero field check
Follow these steps to configure RIP-1 packet zero field check:
To do... Use the command... Remarks
Enter system view system-view —
Enter RIP view rip —
Enable the check of the must be zero
field in RIP-1 packets
checkzero
Required
Enabled by default
Some fields in a RIP-1 packet must be 0, and they are known as must be zero field. For RIP-1, the
must be zero field is checked for incoming packets, and those RIP-1 packets with this field being
nonzero will not be processed.
Setting RIP-2 packet authentication mode
RIP-2 supports two authentication modes: simple authentication and message digest 5 (MD5)
authentication.
Simple authentication cannot provide complete security, because the authentication keys sent along
with packets that are not encrypted. Therefore, simple authentication cannot be applied where high
security is required.
Follow these steps to set RIP-2 packet authentication mode:
To do... Use the command... Remarks
Enter system view system-view —
Enter interface
view interface interface-type
interface-number
—