H3C Technologies H3C S3600 Series Switches - Manual (Page 457)

6-8
z The fast leave processing function works for a port only if the host attached to the port runs IGMPv2
or IGMPv3.
z The configuration performed in system view takes effect on all ports of the switch if no VLAN is
specified; if one or more VLANs are specified, the configuration takes effect on all ports in the
specified VLAN(s).
z The configuration performed in Ethernet port view takes effect on the port no matter which VLAN it
belongs to if no VLAN is specified; if one or more VLANs are specified, the configuration takes
effect on the port only if the port belongs to the specified VLAN(s).
Configuring a Multicast Group Filter
On an IGMP Snooping-enabled switch, the configuration of a multicast group allows the service
provider to define restrictions on multicast programs available to different users.
In an actual application, when a user requests a multicast program, the user’s host initiates an IGMP
report. Upon receiving this report message, the switch checks the report against the ACL rule
configured on the receiving port. If the receiving port can join this multicast group, the switch adds this
port to the IGMP Snooping multicast group list; otherwise the switch drops this report message. Any
multicast data that has failed the ACL check will not be sent to this port. In this way, the service provider
can control the VOD programs provided for multicast users.
Make sure that an ACL rule has been configured before configuring this feature.
Configuring a multicast group filter in system view
Follow these steps to configure a multicast group filter in system view:
To do... Use the command... Remarks
Enter system view system-view —
Configure a multicast group
filter igmp-snooping group-policy
acl-number [ vlan vlan-list ]
Required
No group filter is configured by
default, namely hosts can join
any multicast group.
Configuring a multicast group filter in Ethernet port view
Follow these steps to configure a multicast group filter in Ethernet port view:
To do... Use the command... Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure a multicast group
filter igmp-snooping group-policy
acl-number [ vlan vlan-list ]
Optional
No group filter is configured by
default, namely hosts can join
any multicast group.