H3C Technologies H3C S3600 Series Switches - Manual (Page 983)

1-9
To do… Use the command… Remarks
Enter system view system-view —
Enable the
information center
info-center enable
Optional
Enabled by default.
Enable system
information output to
the console info-center console channel
{ channel-number |
channel-name }
Optional
By default, the switch uses
information channel 0 to output
log/debugging/trap information to the
console.
Configure the output
rules of system
information
info-center source { modu-name |
default } channel
{ channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
Optional
Refer to Table 1-4 for the default
output rules of system information.
Set the format of time
stamp in the output
information info-center timestamp { log |
trap | debugging } { boot | date |
none }
Optional
By default, the time stamp format of
the log and trap output information is
date, and that of the debugging
output information is boot.
To view the debugging information of some modules on the switch, you need to set the type of the
output information to debug when configuring the system information output rules, and use the
debugging command to enable debugging for the corresponding modules.
Table 1-4 Default output rules for different output destinations
LOG TRAP DEBUG
Output
destination
Modules
allowed
Enable
d/disab
led
Severit
y
Enabled/
disabled
Severity
Enabled/
disabled
Severity
Console
default (all
modules) Enable
d warning
s
Enabled
debuggin
g
Enabled
debuggin
g
Monitor
terminal default (all
modules) Enable
d warning
s
Enabled
debuggin
g
Enabled
debuggin
g
Log host
default (all
modules) Enable
d informati
onal
Enabled
debuggin
g
Disabled
debuggin
g
Trap buffer
default (all
modules) Disable
d informati
onal
Enabled warnings Disabled
debuggin
g
Log buffer
default (all
modules) Enable
d warning
s
Disabled
debuggin
g
Disabled
debuggin
g
SNMP NMS
default (all
modules) Disable
d debuggi
ng
Enabled warnings Disabled
debuggin
g