H3C Technologies H3C S3600 Series Switches - Manual (Page 1068)

1-17
To do… Use the command… Remarks
Configure the destination
port destination-port
port-number
Required in a Tcpprivate test
A Tcppublic test is a TCP connection
test on port 7. Use the hwping-server
tcpconnect ip-address 7 command on
the server to configure the listening
service port; otherwise the test will fail.
No port number needs to be configured
on the client; any destination port
number configured on the client will not
take effect.
By default, no destination port number is
configured.
Configure the source IP
address
source-ip ip-address
Optional
By default, the source IP address is not
specified.
Configure the source
port
source-port port-number
Optional
By default, no source port is specified.
Configure the number of
probes per test
count times
Optional
By default, one probe is made per time.
Configure a test
description
description string
Optional
By default, no description information is
configured.
Configure the automatic
test interval
frequency interval
Optional
By default, the automatic test interval is
zero seconds, indicating no automatic
test will be made.
Enable history record history-record enable
Optional
By default, history record is not enabled.
Configure the retaining
time of history record history keep-time
keep-time
Optional
By default, the retaining time of history
record is 120 minutes.
Configure statistics
interval and the
maximum number of
retained statistics
information
statistics { interval interval |
max-group number }
Optional
By default, statistics interval is 120
minutes and up to two pieces of statistics
information can be retained.
Configure the retaining
time of statistics
information
statistics keep-time
keep-time
Optional
By default, the retaining time of statistics
information is 120 minutes.
Configure test start time
and lifetime
test-time begin { hh:mm :ss
[ yyyy/mm/dd ] | now }
lifetime lifetime
Optional
By default, no test start time and lifetime
is configured.
Enable routing table
bypass
sendpacket passroute
Optional
By default, routing table bypass is
disabled.
Configure the TTL ttl number
Optional
By default, TTL is 20.
The sendpacket passroute command
voids the ttl command.