H3C Technologies H3C S3600 Series Switches - Manual (Page 700)

5-2
To do… Use the command… Remarks
Enter port view
interface interface-type
interface-number
—
Enable the DHCP packet rate
limit function
dhcp rate-limit enable
Required
By default, DHCP packet rate
limit is disabled.
Configure the maximum DHCP
packet rate allowed on the port
dhcp rate-limit rate
Optional
By default, the maximum rate is
15 pps.
Enable the port state
auto-recovery function dhcp protective-down
recover enable
Optional
By default, the port state
auto-recovery function is
disabled.
Set the port state
auto-recovery interval dhcp protective-down
recover interval interval
Optional
The port state auto-recovery
interval is 300 seconds.
z Enable the port state auto-recovery function before setting the auto-recovery interval.
z You are not recommended to configure DHCP packet rate limit on the ports of an aggregation
group.
Rate Limit Configuration Example
Network requirements
As shown in Figure 5-1 , Ethernet 1/0/1 of the S3600 switch is connected to the DHCP server. Ethernet
1/0/2 is connected to client B and Ethernet 1/0/11 is connected to client A.
z Enable DHCP snooping on the switch, and specify Ethernet 1/0/1 as the DHCP snooping trusted
port.
z Configure DHCP packet rate limit on Ethernet 1/0/11 and set the maximum DHCP packet rate
allowed on the port to 100 pps.
z Set the port state auto-recovery interval to 30 seconds on the switch.