H3C Technologies H3C S3600 Series Switches - Manual (Page 827)

1-23
Cluster Configuration Examples
Basic Cluster Configuration Example
Network requirements
Three switches compose a cluster, where:
z An S3600 series switch serves as the management device.
z The rest are member devices.
Serving as the management device, the S3600 switch manages the two member devices. The
configuration for the cluster is as follows:
z The two member devices connect to the management device through Ethernet 1/0/2 and Ethernet
1/0/3.
z The management device connects to the Internet through Ethernet 1/0/1.
z Ethernet 1/0/1 belongs to VLAN 2, whose interface IP address is 163.172.55.1.
z All the devices in the cluster share the same FTP server and TFTP server.
z The FTP server and TFTP server use the same IP address: 63.172.55.1.
z The NMS and logging host use the same IP address: 69.172.55.4.
Network diagram
Figure 1-4 Network diagram for HGMP cluster configuration
Internet
Eth1/0/1
Eth1/0/3 Eth1/0/2
Eth1/0/1 Eth1/0/1
69.172.55.4
SNMP/logging host(NMS) FTP/TFTP Server
63.172.55.1
VLAN-interface 2
163.172.55.1
Management
device
Cluster
Member device Member device
MAC:000f.e201.0011 MAC:000f.e201.0012
Configuration procedure
1) Configure the member devices (taking one member as an example)
# Enable NDP globally and on Ethernet 1/0/1.
system-view
[Sysname] ndp enable
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] ndp enable
[Sysname-Ethernet1/0/1] quit
# Enable NTDP globally and on Ethernet 1/0/1.
[Sysname] ntdp enable