H3C Technologies H3C S3600 Series Switches - Manual (Page 756)

1-26
[Sysname-Ethernet1/0/4] monitor-port
[Sysname-Ethernet1/0/4] quit
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] mirrored-to inbound ip-group 2000 monitor-interface
Displaying and Maintaining QoS
To do… Use the command… Remarks
Display the mapping between 802.1p
priority and local precedence display qos
cos-local-precedence-map
Display the priority marking
configuration
display qos-interface { interface-type
interface-number | unit-id }
traffic-priority
Display the protocol packet priority
configuration
display protocol-priority
Display line rate configuration
display qos-interface { interface-type
interface-number | unit-id } line-rate
Display traffic policing configuration
display qos-interface { interface-type
interface-number | unit-id } traffic-limit
Display traffic redirecting configuration
display qos-interface { interface-type
interface-number | unit-id }
traffic-redirect
Display VLAN mapping configuration
display qos-interface { interface-type
interface-number | unit-id }
traffic-remark-vlanid
Display queue scheduling configuration display queue-scheduler
Display traffic accounting configuration
display qos-interface { interface-type
interface-number | unit-id }
traffic-statistic
Display traffic mirroring configuration
display qos-interface { interface-type
interface-number | unit-id } mirrored-to
Display all the QoS configuration
display qos-interface { interface-type
interface-number | unit-id } all
Available in
any view
QoS Configuration Examples
Configuration Example of Traffic policing and Line Rate
Network requirement
An enterprise network connects all the departments through an Ethernet switch. PC 1, with the IP
address 192.168.0.1 belongs to the R&D department and is connected to Ethernet 1/0/1 of the switch.
The marketing department is connected to Ethernet 1/0/2 of the switch.
Configure traffic policing and line rate to satisfy the following requirements:
z Set the maximum rate of outbound packets sourced from the marketing department to 64 kbps.
Drop the packets exceeding the rate limit.
z Set the maximum rate of outbound IP packets sent by PC 1 in the R&D department to 640 kbps.
Drop the packets exceeding the rate limit.