beautypg.com

Configuring fast leave processing, Enabling fast leave processing in system view – H3C Technologies H3C S3600 Series Switches User Manual

Page 456

background image

6-7

Follow these steps to configure timers:

To do...

Use the command...

Remarks

Enter system view

system-view

Configure the aging
timer of the router port

igmp-snooping
router-aging-time
seconds

Optional

By default, the aging time of the router
port is 105 seconds.

Configure the general
query response timer

igmp-snooping
max-response-time
seconds

Optional

By default, the general query response
timeout time is 10 seconds.

Configure the aging
timer of the multicast
member port

igmp-snooping
host-aging-time
seconds

Optional

By default, the aging time of multicast
member ports is 260 seconds

Configuring Fast Leave Processing

With fast leave processing enabled, when the switch receives an IGMP leave message on a port, the

switch directly removes that port from the forwarding table entry for the specific group.

If only one host is attached to the port, enable fast leave processing helps improve bandwidth and

resource usage. If fast leave processing and unknown multicast packet dropping or non-flooding are

enabled on a port to which more than one host is connected, when one host leaves a multicast group,

the other hosts connected to port and interested in the same multicast group will fail to receive multicast

data for that group.

Enabling fast leave processing in system view

Follow these steps to enable fast leave processing in system view:

To do...

Use the command...

Remarks

Enter system view

system-view

Enable fast leave
processing

igmp-snooping fast-leave [ vlan
vlan-list ]

Required

By default, the fast leave processing
feature is disabled.

Enabling fast leave processing in Ethernet port view

Follow these steps to enable fast leave processing in Ethernet view:

To do...

Use the command...

Remarks

Enter system view

system-view

Enter Ethernet port view

interface interface-type
interface-number

Enable fast leave processing
for specific VLANs

igmp-snooping fast-leave
[ vlan vlan-list ]

Required

By default, the fast leave
processing feature is disabled.

This manual is related to the following products: