H3C Technologies H3C S3600 Series Switches - Manual (Page 1065)

1-14
To do… Use the command… Remarks
Configure the retaining time of
statistics information
statistics keep-time keep-time
Optional
By default, the retaining time of
statistics information is 120
minutes.
Configure test start time and
lifetime
test-time begin { hh:mm :ss
[ yyyy/mm/dd ] | now } lifetime
lifetime Optional
By default, no test start time
and lifetime is configured.
Enable routing table bypass sendpacket passroute
Optional
By default, routing table bypass
is disabled.
Configure the TTL ttl number
Optional
By default, TTL is 20.
The sendpacket passroute
command voids the ttl
command.
Configure the automatic test
interval
frequency interval
Optional
By default, the automatic test
interval is zero seconds,
indicating no automatic test will
be made.
Configure the probe timeout
time
timeout time
Optional
By default, a probe times out in
three seconds.
Configure the type of service tos value
Optional
By default, the service type is
zero.
Configure the number of test
packets that will be sent in each
jitter probe
jitter-packetnum number
Optional
By default, each jitter probe will
send 10 packets.
Configure the interval to send
test packets in the jitter test
jitter-interval interval
Optional
By default, the interval is 20
milliseconds.
Configure advantage factor for
a jitter voice test
adv-factor adv-number
By default, the advantage
factor is zero.
Start the test test-enable Required
Display test results
display hwping results
[ admin-name operation-tag ]
Required
You can execute the command
in any view.
6) Configuring SNMP test on HWPing client
Follow these steps to configure SNMP test on HWPing client:
To do… Use the command… Remarks
Enter system view system-view —