H3C Technologies H3C S3600 Series Switches - Manual (Page 25)

1-9
Figure 1-9 Read command line parameters
Type the following command line in the CLI of a device and press Enter. You set the device system time
to 10 o’clock 30 minutes 20 seconds, February 23, 2010.
clock datetime 10:30:20 2/23/2010
You can read any commands more complicated according to Table 1-2 .
CLI View Description
CLI views are designed for different configuration tasks. These are how commands are organized, with
groupings of tasks for related operations. For example, once a user logs into a switch successfully, the
user enters user view, where the user can perform some simple operations such as checking the
operation status and statistics information of the switch. After executing the system-view command,
the user enters system view, and there are other views below this accessible by entering corresponding
commands.
Table 1-3 lists the CLI views provided by S3600 Series Ethernet switches, operations that can be
performed in different CLI views and the commands used to enter specific CLI views.
Table 1-3 CLI views
View
Available
operation
Prompt example Enter method Quit method
User view
Display operation
status and
statistical
information of the
switch
Enter user view
once logging into
the switch. Execute the quit
command to log
out of the switch.
System view
Configure system
parameters
[Sysname]
Execute the
system-view
command in user
view.
Execute the quit
or return
command to
return to user
view.