H3C Technologies H3C S3600 Series Switches - Manual (Page 784)

1-9
2) Configuration procedure
Follow these steps to configure remote port mirroring on the destination switch:
To do… Use the command… Remarks
Enter system view system-view —
Create a VLAN and enter VLAN
view
vlan vlan-id
vlan-id is the ID of the
remote-probe VLAN.
Configure the current VLAN as
a remote-probe VLAN
remote-probe vlan enable Required
Return to system view quit —
Enter the view of the Ethernet
port connecting to the source
switch or an intermediate
switch
interface interface-type
interface-number
—
Configure the current port as
trunk port
port link-type trunk
Required
By default, the port type is
Access.
Configure trunk port to permit
packets from the remote-probe
VLAN
port trunk permit vlan
remote-probe-vlan-id
Required
Return to system view quit —
Create a remote destination
mirroring group mirroring-group group-id
remote-destination
Required
Configure the destination port
for the remote destination
mirroring group
mirroring-group group-id
monitor-port monitor-port
Required
Configure the remote-probe
VLAN for the remote
destination mirroring group mirroring-group group-id
remote-probe vlan
remote-probe-vlan-id
Required
When configuring a destination switch, note that:
z An S3600 series Ethernet switch acting as the destination switch in remote port mirroring
networking does not support bidirectional packet mirroring (the both keyword).
z The destination port of remote port mirroring cannot be a member port of an existing mirroring
group, a fabric port, a member port of an aggregation group, or a port enabled with LACP or STP.
z Only an existing static VLAN can be configured as the remote-probe VLAN. To remove a
remote-probe VLAN, you need to restore it to a normal VLAN first. A remote port mirroring group
gets invalid if the corresponding remote port mirroring VLAN is removed.
Displaying and Maintaining Port Mirroring
To do… Use the command… Remarks
Display port mirroring configuration
on an S3600-EI series Ethernet
switch
display mirroring-group
{ group-id | all | local |
remote-destination |
remote-source }
Available in any view