H3C Technologies H3C S3600 Series Switches - Manual (Page 490)

1-17
To do... Use the command... Remarks
Set the client version
checking period timer dot1x timer ver-period
ver-period-value
Optional
By default, the timer is set to 30
seconds.
As for the dot1x version-user command, if you execute it in system view without specifying the
interface-list argument, the command applies to all ports. You can also execute this command in port
view. In this case, this command applies to the current port only and the interface-list argument is not
needed.
Enabling DHCP-triggered Authentication
After performing the following configuration, 802.1x allows running DHCP on access users, and users
are authenticated when they apply for dynamic IP addresses through DHCP.
Follow these steps to enable DHCP-triggered authentication:
To do... Use the command... Remarks
Enter system view system-view —
Enable DHCP-triggered
authentication
dot1x dhcp-launch
Required
By default, DHCP-triggered
authentication is disabled.
Configuring Guest VLAN
Follow these steps to configure guest VLAN:
To do... Use the command... Remarks
Enter system view system-view —
Configure port access method dot1x port-method portbased
Required
The default port access method
is MAC-address-based. That is,
the macbased keyword is used
by default.
In system
view dot1x guest-vlan vlan-id
[ interface interface-list ]
interface interface-type
interface-number
dot1x guest-vlan vlan-id
Enable the
guest VLAN
function
In port view
quit
Required
By default, the guest VLAN
function is disabled.