H3C Technologies H3C S3600 Series Switches - Manual (Page 302)

1-49
VLAN-VPN Tunnel Configuration Example
Network requirements
z
Switch C and Switch D are the access devices for the service provider network.
z
S3600 switches operate as the access devices of the customer networks, that is, Switch A and
Switch B in the network diagram.
z
Switch C and Switch D are connected to each other through the configured trunk ports of the
switches. The VLAN-VPN tunnel function is enabled in system view, thus implementing
transparent transmission between the customer networks and the service provider network.
Network diagram
Figure 1-11 Network diagram for VLAN-VPN tunnel configuration
Eth 1/0/1
Switch A
Switch D Switch C
Switch B
Eth 1/0/1
GE 1/0/2
GE 1/0/1 GE 1/0/2
GE 1/0/1
Configuration procedure
1) Configure Switch A
# Enable MSTP.
system-view
[Sysname] stp enable
# Add Ethernet 1/0/1 to VLAN 10.
[Sysname] vlan 10
[Sysname-Vlan10] port Ethernet 1/0/1
2) Configure Switch B
# Enable MSTP.
system-view
[Sysname] stp enable
# Add Ethernet 1/0/1 to VLAN 10.
[Sysname] vlan 10
[Sysname-Vlan10] port Ethernet 1/0/1
3) Configure Switch C
# Enable MSTP.
system-view
[Sysname] stp enable
# Enable the VLAN-VPN tunnel function.