H3C Technologies H3C S3600 Series Switches - Manual (Page 751)

1-21
Configuration procedure
Follow these steps to configure VLAN mapping:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure VLAN mapping
traffic-remark-vlanid inbound
acl-rule remark-vlan remark-vlanid
Required
By default, VLAN mapping is
not configured.
Configuring Queue Scheduling
Refer to section Queue Scheduling for information about queue scheduling.
Configuration prerequisites
The algorithm for queue scheduling to be used and the related parameters have been determined.
Configuration procedure
Follow these steps to configure queue scheduling in system view:
To do… Use the command… Remarks
Enter system view system-view —
Configure queue
scheduling
queue-scheduler { strict-priority | wfq
queue0-width queue1-width
queue2-width queue3-width
queue4-width queue5-width
queue6-width queue7-width | wrr
queue0-weight queue1-weight
queue2-weight queue3-weight
queue4-weight queue5-weight
queue6-weight queue7-weight } Required
By default, the queue
scheduling algorithm adopted
on all the ports is WRR. The
default weights of the eight
output queues of a port are 1, 2,
3, 4, 5, 9, 13, and 15 (in the
order queue 0 through queue
7).
Follow these steps to configure queue scheduling in Ethernet port view:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure queue
scheduling
queue-scheduler { wfq
queue0-width queue1-width
queue2-width queue3-width
queue4-width queue5-width
queue6-width queue7-width | wrr
queue0-weight queue1-weight
queue2-weight queue3-weight
queue4-weight queue5-weight
queue6-weight queue7-weight } Required
By default, the queue
scheduling algorithm adopted
on all the ports is WRR. The
default weights of the eight
output queues of a port are 1, 2,
3, 4, 5, 9, 13, and 15 (in the
order queue 0 through queue
7).