beautypg.com

H3C Technologies H3C S3600 Series Switches User Manual

Page 782

background image

1-7

To do…

Use the command…

Remarks

Enter the view of the Ethernet
port that connects to the
intermediate switch or
destination switch

interface interface-type
interface-number

Configure the current port as
trunk port

port link-type trunk

Required

By default, the port type is
Access.

Configure the trunk port to
permit packets from the
remote-probe VLAN

port trunk permit vlan
remote-probe-vlan-id

Required

Return to system view

quit

Create a remote source
mirroring group

mirroring-group group-id
remote-source

Required

Configure source port(s) for the
remote source mirroring group

mirroring-group group-id
mirroring-port
mirroring-port-list { both |
inbound | outbound }

Required

Configure the reflector port for
the remote source mirroring
group

mirroring-group group-id
reflector-port reflector-port

Required

Configure the remote-probe
VLAN for the remote source
mirroring group

mirroring-group group-id
remote-probe vlan
remote-probe-vlan-id

Required

When configuring the source switch, note that:

z

All ports of a remote source mirroring group are on the same device. Each remote source mirroring

group can be configured with only one reflector port.

z

The reflector port cannot be a member port of an existing mirroring group, a fabric port, a member

port of an aggregation group, or a port enabled with LACP or STP. It must be an access port and

cannot be configured with functions like VLAN-VPN, port loopback detection, packet filtering, QoS,

port security, and so on.

z

You cannot modify the duplex mode, port rate, and MDI attribute of a reflector port.

z

Only an existing static VLAN can be configured as the remote-probe VLAN. To remove a

remote-probe VLAN, you need to restore it to a normal VLAN first. A remote port mirroring group

gets invalid if the corresponding remote port mirroring VLAN is removed.

z

Do not configure a port connecting the intermediate switch or destination switch as the mirroring

source port. Otherwise, traffic disorder may occur in the network.

This manual is related to the following products: