H3C Technologies H3C S3600 Series Switches - Manual (Page 1067)

1-16
To do… Use the command… Remarks
Enable routing table bypass sendpacket passroute
Optional
By default, routing table bypass
is disabled.
Configure the TTL ttl number
Optional
By default, TTL is 20.
The sendpacket passroute
command voids the ttl
command.
Configure the automatic test
interval
frequency interval
Optional
By default, the automatic test
interval is zero seconds,
indicating no automatic test will
be made.
Configure the probe timeout
time
timeout time
Optional
By default, a probe times out in
three seconds.
Configure the type of service tos value
Optional
By default, the service type is
zero.
Start the test test-enable Required
Display test results
display hwping results
[ admin-name operation-tag ]
Required
You can execute the command
in any view.
7) Configuring TCP test on HWPing client
Follow these steps to configure TCP test on HWPing client:
To do… Use the command… Remarks
Enter system view system-view —
Enable the HWPing
client function
hwping-agent enable
Required
By default, the HWPing client function is
disabled.
Create an HWPing test
group and enter its view hwping administrator-name
operation- tag Required
By default, no test group is configured.
Configure the test type
test-type { tcpprivate |
tcppublic } Required
By default, the test type is ICMP.
Configure the destination
address
destination-ip ip-address
Required
This IP address and the one configured
on the HWPing server for listening
services must be the same.
By default, no destination address is
configured.