H3C Technologies H3C S3600 Series Switches - Manual (Page 744)

1-14
Task Remarks
Configuring Traffic Redirecting Optional
Configuring VLAN Mapping Optional
Configuring Queue Scheduling Optional
Configuring WRED Optional
Configuring Traffic Accounting Optional
Enabling the Burst Function Optional
Configuring Traffic Mirroring Optional
Configuring Priority Trust Mode
Refer to section Priority Trust Mode for introduction to priority trust mode.
Configuration prerequisites
z The priority trust mode to be adopted has been determined.
z The port where priority trust mode is to be configured has been determined.
z The port priority value has been determined.
Configuration procedure
Follow these steps to configure to trust port priority:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure to trust port priority
and configure the port priority
priority priority-level
Optional
By default, the switch trusts
port priority and the priority of a
port is 0.
Follow these steps to configure to trust packet priority:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure to trust packet
priority
priority trust
Required
By default, the switch trusts
port priority.
Configuration example
z Configure to trust port priority on Ethernet 1/0/1 and set the priority of Ethernet 1/0/1 to 7.
Configuration procedure: