H3C Technologies H3C S3600 Series Switches - Manual (Page 211)

1-21
Network diagram
Figure 1-8 Network diagram for configuring port security mode macAddressElseUserLoginSecureExt
Configuration procedure
z The following configurations involve some AAA/RADIUS configuration commands. For details
about the commands, refer to AAA Operation.
z Configurations on the user host and the RADIUS server are omitted.
z Configure RADIUS parameters
# Create a RADIUS scheme named radius1.
system-view
[Switch] radius scheme radius1
# Specify the primary RADIUS authentication server and primary RADIUS accounting server.
[Switch-radius-radius1] primary authentication 192.168.1.3
[Switch-radius-radius1] primary accounting 192.168.1.2
# Specify the secondary RADIUS authentication server and secondary RADIUS accounting server.
[Switch-radius-radius1] secondary authentication 192.168.1.2
[Switch-radius-radius1] secondary accounting 192.168.1.3
# Set the shared key for message exchange between the switch and the RADIUS authentication
servers to name.
[Switch-radius-radius1] key authentication name
# Set the shared key for message exchange between the switch and the accounting RADIUS servers to
name.
[Switch-radius-radius1] key accounting name
# Set the interval and the number of packet transmission attempts for the switch to send packets to the
RADIUS server.
[Switch-radius-radius1] timer 5
[Switch-radius-radius1] retry 5
# Set the timer for the switch to send real-time accounting packets to the RADIUS server to 15 minutes.