H3C Technologies H3C S3600 Series Switches - Manual (Page 1081)

1-30
Jitter Test
Network requirements
Both the HWPing client and the HWPing server are H3C S3600 series Ethernet switches. Perform an
HWPing jitter test between the two switches to test the delay jitter of the UDP packets exchanged
between this end (HWPing client) and the specified destination end (HWPing server), with the port
number set to 9000.
Network diagram
Figure 1-6 Network diagram for the Jitter test
Configuration procedure
z Configure HWPing Server (Switch B):
# Enable the HWPing server and configure the IP address and port to listen on.
system-view
[Sysname] hwping-server enable
[Sysname] hwping-server udpecho 10.2.2.2 9000
z Configure HWPing Client (Switch A):
# Enable the HWPing client.
system-view
[Sysname] hwping-agent enable
# Create an HWPing test group, setting the administrator name to administrator and test tag to Jitter.
[Sysname] hwping administrator Jitter
# Configure the test type as jitter
[Sysname-hwping-administrator-Jitter] test-type Jitter
# Configure the IP address of the HWPing server as 10.2.2.2.
[Sysname-hwping-administrator-Jitter] destination-ip 10.2.2.2
# Configure the destination port on the HWPing server.
[Sysname-hwping-administrator-Jitter] destination-port 9000
# Configure to make 10 probes per test.
[Sysname-hwping-administrator-http] count 10
# Set the probe timeout time to 30 seconds.
[Sysname-hwping-administrator-Jitter] timeout 30
# Start the test.
[Sysname-hwping-administrator-Jitter] test-enable
# Display test results
[Sysname-hwping-administrator-Jitter] display hwping results administrator Jitter