H3C Technologies H3C S3600 Series Switches - Manual (Page 463)

6-14
To do… Use the command… Remarks
Enter system view system-view —
Enter VLAN interface view interface Vlan-interface interface-number —
Enable simulated joining
igmp host-join group-address [ source-ip
source-address ] port interface-list
Required
Disabled by
default
Configuring simulated joining in Ethernet port view
Follow these steps to configure a port as a simulated group member:
To do... Use the command... Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the current port as a
simulated multicast group
member
igmp host-join group-address
[ source-ip source-address ] vlan vlan-id
Required
Simulated joining is
disabled by default.
z Before configuring a simulated host, enable IGMP Snooping in VLAN view first.
z The port to be configured must belong to the specified VLAN; otherwise the configuration does not
take effect.
z You can use the source-ip source-address command to specify a multicast source address that the
port will join as a simulated host. This configuration takes effect when IGMPv3 Snooping is enabled
in the VLAN.
Configuring a VLAN Tag for Query Messages
By configuring the VLAN tag carried in IGMP general and group-specific queries forwarded and sent by
IGMP Snooping switches, you can enable multicast packet forwarding between different VLANs In a
Layer-2 multicast network environment.
Follow these steps to configure VLAN tag for query message:
To do... Use the command... Remarks
Enter system view system-view —
Configure a VLAN tag for query
messages igmp-snooping
vlan-mapping vlan vlan-id
Required
By default, the VLAN tag in
IGMP general and
group-specific query messages
is not changed.