H3C Technologies H3C S3600 Series Switches - Manual (Page 765)

2-3
To do… Use the command… Remarks
Configure priority
marking
traffic-priority { inbound |
outbound } acl-rule { { dscp
dscp-value | ip-precedence
{ pre-value | from-cos } } | cos
{ pre-value | from-ipprec } |
local-precedence pre-value }*
Optional
Applying a QoS Profile
You can configure to apply a QoS profile dynamically or simply apply a QoS profile manually.
Configuration prerequisites
z To configure to apply a QoS profile dynamically, make sure 802.1x is enabled both globally and on
the port, and the authentication mode is determined. For information about 802.1x, refer to the
802.1x and System Guard module of this manual.
z To apply a QoS profile manually, make sure the port to which the QoS profile is to be applied is
determined.
z The QoS profile to be applied is determined.
Configuration procedure
Follow these steps to configure to apply a QoS profile dynamically:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the mode
to apply a QoS
profile as port-based
qos-profile port-based
Specify the
mode to
apply a QoS
profile
Configure the mode
to apply a QoS
profile as
user-based
undo qos-profile
port-based
Optional
By default, the mode to apply a
QoS profile is user-based.
z If the 802.1x authentication
mode is MAC
address-based, the mode to
apply a QoS profile must be
configured user-based.
z If the 802.1x authentication
mode is port-based, the
mode to apply a QoS profile
must be configured as
port-based.