H3C Technologies H3C S3600 Series Switches - Manual (Page 119)

2-9
Configuration procedure
Follow these steps to associate a port with the protocol-based VLAN:
To do... Use the command... Remarks
Enter system view system-view —
Enter port view
interface interface-type
interface-number
—
Associate the port with the
specified protocol-based
VLAN port hybrid protocol-vlan vlan
vlan-id { protocol-index [ to
protocol-index-end ] | all }
Required
By default, a port is not
associated with any
protocol-based VLAN.
Displaying Protocol-Based VLAN Configuration
To do... Use the command... Remarks
Display the information about the
protocol-based VLAN display vlan [ vlan-id [ to vlan-id ] | all |
dynamic | static]
Display the protocol information and
protocol indexes configured on the
specified VLAN
display protocol-vlan vlan { vlan-id [ to
vlan-id ] | all }
Display the protocol information and
protocol indexes configured on the
specified port display protocol-vlan interface
{ interface-type interface-number [ to
interface-type interface-number ] | all }
Available in
any view
Protocol-Based VLAN Configuration Example
Network requirements
z As shown in Figure 2-2 , Workroom connects to the LAN through port Ethernet 1/0/10 on the S3600
switch.
z IP network and AppleTalk network workstations (hosts) coexist in the Workroom.
z The S3600 switch connects to VLAN 100 (using IP network) through Ethernet 1/0/11 and to VLAN
200 (using AppleTalk network) through Ethernet 1/0/12.
z Configure the switch to automatically assign the IP and AppleTalk packets to proper VLANs for
transmission, so as to ensure the normal communication between the workstations and servers.