H3C Technologies H3C S3600 Series Switches - Manual (Page 764)

2-2
A user-based QoS profile application fails if the traffic classification rule defined in the QoS profile
contains source address information (including source MAC address information, source IP address
information, and VLAN information).
Manual application mode
You can use the apply command to manually apply a QoS profile to a port.
QoS Profile Configuration Task List
Complete the following tasks to configure QoS profile:
Operation Description
Configuring a QoS Profile Required
Applying a QoS Profile Optional
Configuring a QoS Profile
Configuration prerequisites
z The ACL rules used for traffic classification are defined. Refer to the ACL module of this manual for
information about defining ACL rules.
z The type and number of actions in the QoS profile are specified.
Configuration procedure
Follow these steps to configure a QoS profile:
To do… Use the command… Remarks
Enter system view system-view —
Create a QoS profile and
enter QoS profile view
qos-profile profile-name
Required
If the specified QoS profile
already exists, you enter the
QoS profile view directly.
Configure traffic policing
traffic-limit inbound acl-rule
[ union-effect ] [ egress-port
interface-type interface-number ]
target-rate [ burst-bucket
burst-bucket-size ] [ exceed action ]
Optional
Configure packet filtering
packet-filter { inbound | outbound }
acl-rule
Optional
Refer to the ACL module of
this manual for information
about packet filtering.