H3C Technologies H3C S3600 Series Switches - Manual (Page 1074)

1-23
Network requirements
An H3C S3600 series Ethernet switch serves as the HWPing client. An HWPing ICMP test between the
switch and another switch uses ICMP to test the round trip time (RTT) for packets generated by the
HWPing client to travel to and back from the destination switch.
Network diagram
Figure 1-2 Network diagram for the ICMP test
Configuration procedure
z Configure HWPing Client (Switch A):
# Enable the HWPing client.
system-view
[Sysname] hwping-agent enable
# Create an HWPing test group, setting the administrator name to administrator and test tag to ICMP.
[Sysname] hwping administrator icmp
# Configure the test type as icmp.
[Sysname-hwping-administrator-icmp] test-type icmp
# Configure the destination IP address as 10.2.2.2.
[Sysname-hwping-administrator-icmp] destination-ip 10.2.2.2
# Configure to make 10 probes per test.
[Sysname-hwping-administrator-icmp] count 10
# Set the probe timeout time to 5 seconds.
[Sysname-hwping-administrator-icmp] timeout 5
# Set the maximum number of history records that can be saved to 5.
[Sysname-hwping-administrator-icmp] history-records 5
# Start the test.
[Sysname-hwping-administrator-icmp] test-enable
# Display test results.
[Sysname-hwping-administrator-icmp] display hwping results administrator icmp
HWPing entry(admin administrator, tag icmp) test result:
Destination ip address:10.2.2.2
Send operation times: 10 Receive response times: 10
Min/Max/Average Round Trip Time: 3/6/3
Square-Sum of Round Trip Time: 145
Last succeeded test time: 2000-4-2 20:55:12.3
Extend result:
SD Maximal delay: 0 DS Maximal delay: 0