4 dma fly-by transfer (sdram/fcram -> i/o) – FUJITSU MB91460 SERIES FR60 User Manual
Page 613

597
Chapter 31 External Bus
10.DMA Access Operation
•
For the I/O device on the data output side, a read strobe of three bus cycles extended by the I/O wait cycle
and I/O hold wait cycle is generated.
•
For SDRAM/FCRAM on the receiving side, a WRIT command is issued at the timing that allows writing after
the I/O wait cycle. The I/O wait cycle may be longer depending on the SDRAM/FCRAM bank active state and
SDRAM/FCRAM wait setting.
•
The I/O hold wait cycle does not affect the write strobe. Note, however, that the CS signal is retained until the
fly - by bus access cycles end.
•
For fly - by transfer from an I/O device to SDRAM/FCRAM, be sure to set the HLD bit in the DMAC I/O wait
register (IOWR) to 1 to enable the I/O hold wait cycle.
•
Fly - by transfer must always be performed between data buses having the same bus width.
10.4 DMA Fly-By Transfer (SDRAM/FCRAM -> I/O)
This section describes the operation of DMA fly - by transfer (SDRAM/FCRAM device to I/O).
■
DMA Fly-By Transfer (SDRAM/FCRAM -> I/O)
Figure 1.10 - 4 shows an operation timing chart assuming TYP3 to TYP0 set to 1000B, AWR set to 0051H, and
IOWR set to 42H.