Disabling all channels, Transfer stop requests from peripheral circuits – FUJITSU MB91460 SERIES FR60 User Manual

Page 382

366

Chapter 26 DMA Controller

3.DMA Controller (DMAC) Operation

●

Disabling all channels

If the operation of all channels is disabled with the DMA operation enable bit DMAE, all DMAC operations,
including operations on active channels, are stopped. Then, even if the operation of all channels is enabled again,
no transfer is performed unless a channel is restarted. In this case, no interrupt whatever occurs.

■

Stopping Due To an Error

In addition to normal end after transfer for the number of times specified, stopping as the result of various types of
errors and the forced stopping are provided.

●

Transfer stop requests from peripheral circuits

Depending on the peripheral circuit that outputs a transfer request, a transfer stop request is issued when an
error is detected (Example: Error when data is received at or sent from a communications system peripheral).

The DMAC, when it receives such a transfer stop request, displays "Transfer stop request" as the end code and
stops the transfer on the corresponding channel.

Table 3-6 Stopping due to an Error

*1 : A transfer stop request is issued when an error is detected

For details of the conditions under which a transfer stop request is generated, see the specifications for each
peripheral circuit.

EIS

Function

Transfer stop request

10110

11000

11010

11100

0000

USART 0 RX *1

USART 1 RX *1

USART 4 RX *1

USART 5 RX *1

Yes

10000

10010

10100

10110

11000

11010

11100

11110

0011

USART 0 RX *1

USART 1 RX *1

USART 2 RX *1

USART 3 RX *1

USART 4 RX *1

USART 5 RX *1

USART 6 RX *1

USART 7 RX *1

Yes

10000

10010

10100

10110

11000

11010

11100

11110

0100

USART 8 RX *1

USART 9 RX *1

USART 10 RX *1

USART 11 RX *1

USART 12 RX *1

USART 13 RX *1

USART 14 RX *1

USART 15 RX *1

Yes

others

None