beautypg.com

2 how do i change to stop mode, 5 how do i recover from sleep mode – FUJITSU MB91460 SERIES FR60 User Manual

Page 178

background image

162

Chapter 10 Standby

7.Q&A

7.2 How do I change to stop mode?

• When operating on the main PLL clock, the operating clock must be set to the main clock divided

by two.

See “

7.3 How do I select the operating clock source? (Page No.202)

for details about changing

the operating clock.

• Before you can change to stop mode, you must first set the synchronous standby operation

enable bit (TBCR.SYNCS). See section 7.1.

• Set using the stop mode bit (STCR.STOP).

Note: Some restrictions apply when changing to stop mode. See

8.

Caution (Page No.165)

” for

details.

7.3 How do I set pins to high impedance (Hi-z) during stop mode?

Set using the high impedance mode bit (STCR.HIZ).

Note: Some ports do not go to high impedance in some circumstances. (See

5.2 Stop mode (Page

No.160)

”.)

7.4 How do I halt the main clock oscillation during stop mode?

Use the main clock oscillation stop bit (STCR.OSCD1).

7.5 How do I recover from sleep mode?

Two methods are available to recover from sleep mode.

• Generation of a valid interrupt request changes to RUN mode (restores normal operation).

If using interrupt processing, remember to set the I flag (I), interrupt level mask register (ILM),
and interrupt control register (ICR).

• An INIT pin input or generation of a watchdog reset invokes an initialization reset (INIT) followed by

an operation reset (RST).

Operation

Stop mode bit (STOP)

When you do not want to change to stop mode

Set to “0”.

To change to stop mode

Set to “1”.

Operation

High impedance mode bit (HIZ)

When you do not want to set pins to high impedance during stop
mode

Set to “0”.

To set pins to high impedance during stop mode

Set to “1”.

Operation

Main clock oscillation stop bit (OSCD1)

When you do not want to halt the main clock oscillation in stop
mode

Set to “0”.

To halt the main clock oscillation during stop mode

Set to “1”.