FUJITSU MB91460 SERIES FR60 User Manual
Page 538

522
Chapter 31 External Bus
2.External Bus Interface Registers
[Bits 15-12] W15-12 (First Wait Cycle)
These bits set the number of auto-wait cycles to be inserted into the first access cycle of each cycle. Except
for the burst access cycles, only this wait setting is used.
"Settings for the Number of Auto-Wait Cycles (During First Access)" lists the settings for the number
of auto-wait cycles during first access.
[Bits 11-8] W11-08 (Inpage Access Wait Cycle)
These bits set the number of auto-wait cycles to be inserted into the inpage access cycle during burst access.
They are valid only for burst cycles.
"Settings for the Number of Auto-Wait Cycles (During Burst Access)" lists the settings for the
number of auto-wait cycles during burst access.
If the same value is set for the first access wait cycle and inpage access wait cycle, the access time for the
address in each access cycle is not the same. This is because the inpage access cycle contains an address
output delay.
Table 2-5 Settings for the Number of Auto-Wait Cycles (During First Access)
W15
W14
W13
W12
First access wait cycle
0
0
0
0
Auto-wait cycle 0
0
0
0
1
Auto-wait cycle 1
...
...
1
1
1
1
Auto-wait cycle 15
Table 2-6 Settings for the Number of Auto-Wait Cycles (During Burst Access)
W11
W10
W09
W08
Inpage access wait cycle
0
0
0
0
Auto-wait cycle 0
0
0
0
1
Auto-wait cycle 1
...
...
1
1
1
1
Auto-wait cycle 15