Yaskawa Large Capacity Sigma II Series - Manual (Page 395)

Appendix A List of Parameters
A-12
* When Pn50A.0 is set to 0 for the SGDB SERVOPACK, only the following modes are compati-
ble: Pn50A.1=7, Pn50A.3=8, and Pn50B.0=8.
Pn50C 0 /SPD-D Signal Mapping
(Internal Set Speed Selection) 0 to F Same as above. 8: OFF
1 /SPD-A Signal Mapping
(Internal Set Speed Selection) 0 to F Same as above. 8: OFF
2 /SPD-B Signal Mapping
(Internal Set Speed Selection) 0 to F Same as above. 8: OFF
3 /C-SEL Signal Mapping
(Control Mode Switching) 0 to F Same as above. 8: OFF
Pn50D 0 /ZCLAMP Signal Mapping
(Zero Clamping) 0 to F Same as above. 8: OFF
1 /INHIBIT Signal Mapping
(Disabling Reference Pulse) 0 to F Same as above. 8: OFF
2 /G-SEL Signal Mapping
(Gain Switching) 0 to F Same as above. 8: OFF
3 (Reserved) 0 to F Same as above. 8: OFF
Table A.3 Input Signal Selections (cont’d)
Parameter Digit
Place
Name Setting Contents Factory
Setting