Yaskawa Large Capacity Sigma II Series - Manual (Page 249)

6.2 Applied Operation
6-29
6
„ Speed Reference Offset Manual Adjustment
Follow the procedure below to manually adjust the speed reference offset.
Using the Hand-held Digital Operator
1. Press the DSPL/SET Key to select the auxiliary function mode.
2. Select the parameter Fn00A.
Press the Left or Right Cursor Key to select the digit.
Press the Up or Down Cursor Key to change the number.
3. Press the DATA/ENTER Key, and the display will be as shown below. The manual
adjustment mode for the speed reference offset will be entered.
4. Turn ON the Servo ON (/S-ON) signal. The display will be as shown below.
5. Press the Left or Right Cursor Key, to display the speed reference offset amount.
6. Press the Up or Down Cursor Key to adjust the amount of offset (adjustment of the
speed reference offset).
7. Press the Left or Right Cursor Key to return to the display in the above step 4.
8. Press the DATA/ENTER Key to return to the auxiliary function mode display.
This completes the speed reference offset manual adjustment.