Yaskawa Large Capacity Sigma II Series - Manual (Page 244)

6 Using the Digital Operator
6.2.2 Controlling Operation Through the Digital Operator
6-24
Using the Panel Operator
1. Press the MODE/SET Key to select Fn002 in the auxiliary function mode.
2. Press the DATA/SHIFT Key for a minimum of one second to select the Panel Operator
operation mode. Operation is now possible using the Panel Operator.
3. Press the MODE/SET Key to set to the servo ON state (with motor power turned ON).
4. Press the Up Cursor Key or Down Cursor Key to operate the motor. The motor keeps
operating while the key is pressed.
5. Press the MODE/SET Key to set to the servo OFF state (with motor power turned OFF).
Alternatively, press the DATA/SHIFT Key for a minimum of one second to set to the
servo OFF state.
6. Press the DATA/SHIFT Key for a minimum of one second and the display will revert to
Fn002 in the auxiliary function mode.
This ends operation under Panel Operator control.
The motor speed for operation under control using Digital Operator or Panel Operator can be
changed with a parameter:
Parameter: Pn304, Unit: min
-1
, Standard setting: 500
The rotation direction of the servomotor depends on the setting of parameter Pn000.0 “Rotation Direc-
tion.” The above example shows a case where Pn000.0 is set to “0” as a factory setting.
MODE/SET DATE/
Motor forward
rotation Motor reverse
rotation
INFO