Yaskawa Large Capacity Sigma II Series - Manual (Page 255)

6.2 Applied Operation
6-35
6
6.2.6 Checking the Motor Model
Set the parameter Fn011 to select the motor model check mode. This mode is used for the
motor maintenance, and can also be used to check the specification codes of SERVOPACKs
made with special specifications.
Follow the procedure below to check the motor model.
Using the Hand-held Digital Operator
1. Press the DSPL/SET Key to select the auxiliary function mode.
2. Select the parameter Fn011. Press the Left or Right Cursor Key to select the digit. Press
the Up or Down Cursor Key to change the number.
3. Press the DATA/ENTER Key to display the servomotor model and voltage code.
4. Press the DSPL/SET Key to display servomotor capacity.
Voltage Servomotor Model
Code Voltage Code Servomotor Model
00 100 VAC or 140 VDC 00 SGMAH
01 200 VAC or 280 VDC 01 SGMPH
02 400 VAC or 560 VDC 02 SGMSH
03
SGMGH-†A (1500 min
-1
)
04
SGMGH-†B (1000 min -1 )
05 SGMDH
06 SGMUH
0B SGMBH
Servomotor model Voltage
Capacity: Displayed value × 10 (W)
In this example, the capacity is 100 W.