Yaskawa Large Capacity Sigma II Series - Manual (Page 258)

6 Using the Digital Operator
6.2.7 Checking the Software Version
6-38
6. Press the MODE/SET Key to display the SERVOPACK’s specification code (Y Specifi-
cation code).
7. Press the DATA/SHIFT Key for a minimum of one second to return to the auxiliary
function mode display. Pressing the DATA/SHIFT Key after the above display 3. to 5.
will also return to the auxiliary function mode display.
This completes the checking motor type procedure.
6.2.7 Checking the Software Version
This mode is used for the motor maintenance.
Set Fn012 to select the software-version check mode.
Follow the procedure below to check the software version.
Using the Hand-held Digital Operator
1. Select the parameter Fn012.
2. Press the DATA/ENTER Key and the SERVOPACK’s Software version will be dis-
played.
3. Press the DSPL/SET Key and the software version of the encoder mounted on the motor
will be displayed.
4. Press the DATA/ENTER Key to return to the parameter number display.
This completes the checking software version procedure.
This example shows specification code "Y10"
(Indicated in decimal).
Software Version Display
Software
version
Software Version Display
Software version