Yaskawa Large Capacity Sigma II Series - Manual (Page 235)

6.1 Basic Operation
6-15
6
6.1.7 Operation in Monitor Mode
The monitor mode can be used for monitoring the reference values, I/O signal status, and
SERVOPACK internal status.
The monitor mode can be set during motor operation.
„ Using the Monitor Mode
The example below shows how to display 1500, the contents of monitor number Un000
when the servomotor rotates at 1500 min
-1
.
With the Hand-held Digital Operator
1. Press the DSPL/SET Key to select the monitor mode.
2. Press the Up or Down Cursor Key to select the monitor number to be displayed.
3. Press the DATA/ENTER Key to display the data for the monitor number selected in the
above step 2.
4. Press the DATA/ENTER Key once more to return to the monitor number display.
This completes the example procedure for displaying 1500, the contents of monitor
number Un000.
Using the Panel Operator
1. Press the MODE/SET Key to select the monitor mode.
2. Press the Up or Down Cursor Key to select the monitor number to be displayed.
3. Press the DATA/SHIFT Key for a minimum of one second to display the data for the
monitor number selected in the above step2.
Data
MODE/SET DATE/
Data