Yaskawa Large Capacity Sigma II Series - Manual (Page 263)

6.2 Applied Operation
6-43
6
Using the Panel Operator
1. Press the MODE/SET Key to select the auxiliary function mode.
2. Press the Up or Down Cursor Key to select the parameter Fn005.
3. Press the DATA/SHIFT Key for a minimum of one second. The following display will
appear.
4. Press the MODE/SET Key and the display will change as shown below. The parameter
will be initialized.
5. Press the DATA/SHIFT Key for a minimum of one second to return to the auxiliary
function mode display.
This completes the initialization of parameter settings.
Parameters will not be initialized by pressing the DSPL/SET or MODE/SET Key with the servo ON.
Turn the power OFF and then back ON after initialization.
MODE/SET DATE/
Flashing for
one second
Flashing during
Initialization
End
INFO