20 show storm-control, 20 show storm-control - 60, Switching commands at8404 – Kontron AT8404 CLI User Manual
Page 96

Switching Commands
AT8404
AT8404 CLI Reference Manual
Page 2 - 60
2.12.20
show storm-control
This command displays switch configuration information. If you do not use any of the optional parameters, this
command displays global storm control configuration parameters:
•
Broadcast Storm Recovery Mode may be enabled or disabled. The factory default is disabled.
•
802.3x Flow Control Mode may be enabled or disabled. The factory default is disabled.
Use the all keyword to display the per-port configuration parameters for all interfaces, or specify the slot/port
to display information about a specific interface.
Example: The following shows example CLI display output for the command.
(Broadcom FASTPATH Routing) #show storm-control
802.3x Flow Control Mode....................... Disable
Example: The following shows example CLI display output for the command.
(Broadcom FASTPATH Routing) #show storm-control 1/0/1
Bcast Bcast Mcast Mcast Ucast Ucast
Intf Mode Level Mode Level Mode Level
------ ------- -------- ------- -------- ------- --------
1/0/1 Disable 5% Disable 5% Disable 5%
Example: The following shows an example of part of the CLI display output for the command.
(Broadcom FASTPATH Routing) #show storm-control all
Bcast Bcast Mcast Mcast Ucast Ucast
Intf Mode Level Mode Level Mode Level
------ ------- -------- ------- -------- ------- --------
1/0/1 Disable 5% Disable 5% Disable 5%
1/0/2 Disable 5% Disable 5% Disable 5%
1/0/3 Disable 5% Disable 5% Disable 5%
1/0/4 Disable 5% Disable 5% Disable 5%
1/0/5 Disable 5% Disable 5% Disable 5%
Format
show storm-control [all |
Mode
Privileged EXEC
Term
Definition
Bcast Mode
Shows whether the broadcast storm control mode is enabled or disabled. The factory default
is disabled.
Bcast Level
The broadcast storm control level.
Mcast Mode
Shows whether the multicast storm control mode is enabled or disabled.
Mcast Level
The multicast storm control level.
Ucast Mode
Shows whether the Unknown Unicast or DLF (Destination Lookup Failure) storm control mode
is enabled or disabled.
Ucast Level
The Unknown Unicast or DLF (Destination Lookup Failure) storm control level.