Kontron AT8404 CLI - Manual (Page 217)

AT8404 Utility Commands
Page 4 - 3 AT8404 CLI Reference Manual
4.2 Dual Image Commands
FASTPATH software supports a dual image feature that allows the switch to have two software images in the
permanent storage. You can specify which image is the active image to be loaded in subsequent reboots. This
feature allows reduced down-time when you upgrade or downgrade the software.
4.2.1 delete
This command deletes the supplied image file from the permanent storage. The image to be deleted must be a
backup image. If this image is the active image, or if this image is activated, an error message displays.
4.2.2 boot system
This command activates the specified image. It will be the active-image for subsequent reboots and will be loaded
by the boot loader. The current active-image is marked as the backup-image for subsequent reboots.
4.2.3 show bootvar
This command displays the version information and the activation status for the current active and backup images.
The command also displays any text description associated with an image. This command displays the switch
activation status.
4.2.4 filedescr
This command associates a given text description with an image. Any existing description will be replaced.
4.3 ATCA commands
4.3.1 set board sensor threshold
This command sets a new threashold value for a sensor. The (of SDR) for a specific sensor is displayed
by the related “show” command
Mode Priviledged EXEC
Format delete {image1 | image2}
Mode Privileged EXEC
Format boot system
Mode Privileged EXEC
Format show bootvar
Mode Privileged EXEC
Format filedescr {image1 | image2}
Mode Privileged EXEC
Format set board sensor threshold
Mode Priviledged EXEC