Kontron AT8404 CLI - Manual (Page 148)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 112
2.22.3.1 no port-security max-static
This command sets maximum number of statically locked MAC addresses to the default value.
2.22.4 port-security mac-address
This command adds a MAC address to the list of statically locked MAC addresses. The is the VLAN ID.
2.22.4.1 no port-security mac-address
This command removes a MAC address from the list of statically locked MAC addresses.
2.22.5 port-security mac-address move
This command converts dynamically locked MAC addresses to statically locked addresses.
2.22.6 show port-security
This command displays the port-security settings. If you do not use a parameter, the command displays the settings
for the entire system. Use the optional parameters to display the settings on a specific interface or on all interfaces.
For each interface, or for the interface you specify, the following information appears:
Format no port-security max-static
Mode Interface Config
Format port-security mac-address
Mode Interface Config
Format no port-security mac-address
Mode Interface Config
Format port-security mac-address move
Mode Interface Config
Format show port-security [{ | all}]
Mode Privileged EXEC
Term Definition
Admin Mode Port Locking mode for the entire system. This field displays if you do not supply any
parameters.
Term Definition
Admin Mode Port Locking mode for the Interface.
Dynamic Limit Maximum dynamically allocated MAC Addresses.
Static Limit Maximum statically allocated MAC Addresses.
Violation Trap
Mode
Whether violation traps are enabled.