Kontron AT8404 CLI - Manual (Page 72)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 36
2.7.3 show switchport protected
This command displays the status of all the interfaces, including protected and unprotected interfaces.
2.7.4 show interfaces switchport
This command displays the status of the interface (protected/unprotected) under the groupid.
2.8 GARP Commands
This section describes the commands you use to configure Generic Attribute Registration Protocol (GARP) and view
GARP status. The commands in this section affect both GARP VLAN Registration Protocol (GVRP) and Garp
Multicast Registration Protocol (GMRP). GARP is a protocol that allows client stations to register with the switch for
membership in VLANS (by using GVMP) or multicast groups (by using GVMP).
2.8.1 set garp timer join
This command sets the GVRP join time for one port (Interface Config mode) or all (Global Config mode) and per
GARP. Join time is the interval between the transmission of GARP Protocol Data Units (PDUs) registering (or re-
registering) membership for a VLAN or multicast group. This command has an effect only when GVRP is enabled.
The time is from 10 to 100 (centiseconds). The value 20 centiseconds is 0.2 seconds.
Format show switchport protected
Mode • Privileged EXEC
• User EXEC
Term Definition
Group ID The number that identifies the protected port group.
Name An optional name of the protected port group. The name can be up to 32 alphanumeric
characters long, including blanks. The default is blank.
List of Physical
Ports
List of ports, which are configured as protected for the group identified with . If no
port is configured as protected for this group, this field is blank.
Format show interfaces switchport
Mode • Privileged EXEC
• User EXEC
Term Definition
Name A string associated with this group as a convenience. It can be up to 32 alphanumeric
characters long, including blanks. The default is blank. This field is optional.
Protected Indicates whether the interface is protected or not. It shows TRUE or FALSE. If the group is a
multiple groups then it shows TRUE in Group .
Default 20
Format set garp timer join <10-100>
Mode • Interface Config
• Global Config