Kontron AT8404 CLI - Manual (Page 73)

AT8404 Switching Commands
Page 2 - 37 AT8404 CLI Reference Manual
2.8.1.1 no set garp timer join
This command sets the GVRP join time (for one or all ports and per GARP) to the default and only has an effect
when GVRP is enabled.
2.8.2 set garp timer leave
This command sets the GVRP leave time for one port (Interface Config mode) or all ports (Global Config mode) and
only has an effect when GVRP is enabled. Leave time is the time to wait after receiving an unregister request for a
VLAN or a multicast group before deleting the VLAN entry. This can be considered a buffer time for another station
to assert registration for the same attribute in order to maintain uninterrupted service. The leave time is 20 to 600
(centiseconds). The value 60 centiseconds is 0.6 seconds.
2.8.2.1 no set garp timer leave
This command sets the GVRP leave time on all ports or a single port to the default and only has an effect when
GVRP is enabled.
2.8.3 set garp timer leaveall
This command sets how frequently Leave All PDUs are generated. A Leave All PDU indicates that all registrations
will be unregistered. Participants would need to rejoin in order to maintain registration. The value applies per port
and per GARP participation. The time may range from 200 to 6000 (centiseconds). The value 1000 centiseconds is
10 seconds. You can use this command on all ports (Global Config mode) or a single port (Interface Config mode),
and it only has an effect only when GVRP is enabled.
2.8.3.1 no set garp timer leaveall
This command sets how frequently Leave All PDUs are generated the default and only has an effect when GVRP
is enabled.
Format no set garp timer join
Mode • Interface Config
• Global Config
Default 60
Format set garp timer leave <20-600>
Mode • Interface Config
• Global Config
Format no set garp timer leave
Mode • Interface Config
• Global Config
Default 1000
Format set garp timer leaveall <200-6000>
Mode • Interface Config
• Global Config
Format no set garp timer leaveall