Kontron AT8404 CLI - Manual (Page 43)

AT8404 Switching Commands
Page 2 - 7 AT8404 CLI Reference Manual
2.1.14 show port protocol
This command displays the Protocol-Based VLAN information for either the entire system, or for the indicated group.
2.2 Spanning Tree Protocol (STP) Commands
This section describes the commands you use to configure Spanning Tree Protocol (STP). STP helps prevent
network loops, duplicate messages, and network instability.
2.2.1 spanning-tree
This command sets the spanning-tree operational mode to enabled.
2.2.1.1 no spanning-tree
This command sets the spanning-tree operational mode to disabled. While disabled, the spanning-tree configuration
is retained and can be changed, but is not activated.
Link Trap This object determines whether or not to send a trap when link status changes. The factory
default is enabled.
LACP Mode LACP is enabled or disabled on this port.
Format show port protocol { | all}
Mode Privileged EXEC
Term Definition
Group Name The group name of an entry in the Protocol-based VLAN table.
Group ID The group identifier of the protocol group.
Protocol(s) The type of protocol(s) for this group.
VLAN The VLAN associated with this Protocol Group.
Interface(s) Lists the slot/port interface(s) that are associated with this Protocol Group.
Note: STP is disabled by default. When you enable STP on the switch, STP is still disabled on each port.
Note: If STP is disabled, the system does not forward BPDU messages.
Default disabled
Format spanning-tree
Mode Global Config
Format no spanning-tree
Mode Global Config
Term Definition