Kontron AT8404 CLI - Manual (Page 116)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 80
2.15.7 show mac-address-table staticfiltering
This command displays the Static Filtering entries in the Multicast Forwarding Database (MFDB) table.
2.16 DHCP Snooping Configuration Commands
This section describes commands you use to configure DHCP Snooping.
2.16.1 ip dhcp snooping
Use this command to enable DHCP Snooping globally.
2.16.1.1 no ip dhcp snooping
Use this command to disable DHCP Snooping globally.
2.16.2 ip dhcp snooping vlan
Use this command to enable DHCP Snooping on a list of comma-separated VLAN ranges.
Note: Only multicast address filters will have destination port lists.
Format show mac-address-table staticfiltering
Mode Privileged EXEC
Term Definition
Mac Address A unicast MAC address for which the switch has forwarding and or filtering information. As the
data is gleaned from the MFDB, the address will be a multicast address. The format is 6 or 8
two-digit hexadecimal numbers that are separated by colons, for example 01:23:45:67:89:AB.
In an IVL system the MAC address will be displayed as 8 bytes.
Type The type of the entry. Static entries are those that are configured by the end user. Dynamic
entries are added to the table as a result of a learning process or protocol.
Description The text description of this multicast table entry.
Interfaces The list of interfaces that are designated for forwarding (Fwd:) and filtering (Flt:).
Default disabled
Format ip dhcp snooping
Mode Global Config
Format no ip dhcp snooping
Mode Global Config
Default disabled
Format ip dhcp snooping vlan
Mode Global Config