Kontron AT8404 CLI - Manual (Page 92)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 56
2.12.10 storm-control multicast all
This command enables multicast storm recovery mode for all interfaces. If the mode is enabled, multicast storm
recovery is active, and if the rate of L2 multicast traffic ingressing on an interface increases beyond the configured
threshold, the traffic will be dropped. Therefore, the rate of multicast traffic will be limited to the configured threshold.
2.12.10.1 no storm-control multicast all
This command disables multicast storm recovery mode for all interfaces.
2.12.11 storm-control multicast all level
This command configures the multicast storm recovery threshold for all interfaces as a percentage of link speed and
enables multicast storm recovery mode. If the mode is enabled, multicast storm recovery is active, and if the rate of
L2 multicast traffic ingressing on an interface increases beyond the configured threshold, the traffic will be dropped.
Therefore, the rate of multicast traffic will be limited to the configured threshold.
2.12.11.1 no storm-control multicast all level
This command sets the multicast storm recovery threshold to the default value for all interfaces and disables
multicast storm recovery.
2.12.12 storm-control multicast all rate
Use this command to configure the multicast storm recovery threshold for all interfaces in packets per second. If the
mode is enabled, multicast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface
increases beyond the configured threshold, the traffic is dropped. Therefore, the rate of multicast traffic is limited to
the configured threshold.
Default disabled
Format storm-control multicast all
Mode Global Config
Format no storm-control multicast all
Mode Global Config
Default 5
Format storm-control multicast all level <0-100>
Mode Global Config
Format no storm-control multicast all level
Mode Global Config
Default 0
Format storm-control multicast rate <0-33554431>
Mode Global Config