Kontron AT8404 CLI - Manual (Page 168)

Switching Commands AT8404
AT8404 CLI Reference Manual Page 2 - 132
2.27.1.1 no isdp run
This command disables ISDP on the switch.
2.27.2 isdp holdtime
This command configures the hold time for ISDP packets that the switch transmits. The hold time specifies how long
a receiving device should store information sent in the ISDP packet before discarding it. The range is given in
seconds.
2.27.3 isdp timer
This command sets the period of time between sending new ISDP packets. The range is given in seconds.
2.27.4 isdp advertise-v2
This command enables the sending of ISDP version 2 packets from the device.
2.27.4.1 no isdp advertise-v2
This command disables the sending of ISDP version 2 packets from the device.
2.27.5 isdp enable
This command enables ISDP on the interface.
Format no isdp run
Mode Global Config
Default 180 seconds
Format isdp holdtime <10-255>
Mode Global Config
Default 30 seconds
Format isdp timer <5-254>
Mode Global Config
Default Enabled
Format isdp advertise-v2
Mode Global Config
Format no isdp advertise-v2
Mode Global Config
Default Enabled
Format isdp enable
Mode Interface Config