Kontron AT8404 CLI - Manual (Page 169)

AT8404 Switching Commands
Page 2 - 133 AT8404 CLI Reference Manual
2.27.5.1 no isdp enable
This command disables ISDP on the interface.
2.27.6 clear isdp counters
This command clears ISDP counters.
2.27.7 clear isdp table
This command clears entries in the ISDP table.
2.27.8 show isdp
This command displays global ISDP settings.
Format no isdp enable
Mode Interface Config
Format clear isdp counters
Mode Privileged EXEC
Format clear isdp table
Mode Privileged EXEC
Format show isdp
Mode Privileged EXEC
Term Definition
Timer The frequency with which this device sends ISDP packets. This value is given in seconds.
Hold Time The length of time the receiving device should save information sent by this device. This
value is given in seconds.
ISDPv2
Advertisements
The setting for sending ISDPv2 packets. If disabled, version 1 packets are transmitted.
Device ID The Device ID advertised by this device. The format of this Device ID is characterized by the
value of the Device ID Format object.
Device ID Format
Capability
Indicates the Device ID format capability of the device.
• serialNumber indicates that the device uses a serial number as the format for its Device
ID.
• macAddress indicates that the device uses a Layer 2 MAC address as the format for its
Device ID.
• other indicates that the device uses its platform-specific format as the format for its
Device ID.
Device ID Format Indicates the Device ID format of the device.
• serialNumber indicates that the value is in the form of an ASCII string containing the
device serial number.
• macAddress indicates that the value is in the form of a Layer 2 MAC address.
• other indicates that the value is in the form of a platform specific ASCII string containing
info that identifies the device. For example, ASCII string contains serialNumber appended/
prepended with system name.