Kontron AT8404 CLI - Manual (Page 303)

AT8404 Management Commands
Page 5 - 27 AT8404 CLI Reference Manual
5.8.17.1 no snmp trap link-status
This command disables link status traps by interface.
5.8.18 snmp trap link-status all
This command enables link status traps for all interfaces.
5.8.18.1 no snmp trap link-status all
This command disables link status traps for all interfaces.
5.8.19 show snmpcommunity
This command displays SNMP community information. Six communities are supported. You can add, change, or
delete communities. The switch does not have to be reset for changes to take effect.
The SNMP agent of the switch complies with SNMP Versions 1, 2 or 3. For more information about the SNMP
specification, see the SNMP RFCs. The SNMP agent sends traps through TCP/IP to an external SNMP manager
based on the SNMP configuration (the trap receiver and other SNMP community parameters).
Note: This command is valid only when the Link Up/Down Flag is enabled.
Format no snmp trap link-status
Mode Interface Config
Note: This command is valid only when the Link Up/Down Flag is enabled. See “snmp-server enable
traps linkmode” on page 5 - 24.
Format snmp trap link-status all
Mode Global Config
Note: This command is valid only when the Link Up/Down Flag is enabled. See “snmp-server enable
traps linkmode” on page 5 - 24.
Format no snmp trap link-status all
Mode Global Config
Format show snmpcommunity
Mode Privileged EXEC
Term Definition
SNMP Community
Name
The community string to which this entry grants access. A valid entry is a case-sensitive
alphanumeric string of up to 16 characters. Each row of this table must contain a unique
community name.