Kontron AT8404 CLI - Manual (Page 291)

AT8404 Management Commands
Page 5 - 15 AT8404 CLI Reference Manual
5.7 User Account Commands
This section describes the commands you use to add, manage, and delete system users. FASTPATH software has
two default users: admin and guest. The admin user can view and configure system settings, and the guest user
can view settings.
5.7.1 users name
This command adds a new user account, if space permits. The account can be up to eight characters
in length. You can use alphanumeric characters as well as the dash (‘-’) and underscore (‘_’). You can define up to
six user names.
5.7.1.1 no users name
This command removes a user account.
5.7.2 users name unlock
Use this command to unlock a locked user account. Only a user with read/write access can re-activate a locked user
account.
5.7.3 users passwd
Use this command to change a password. Passwords are a maximum of 64 alphanumeric characters. If a user is
authorized for authentication or encryption is enabled, the password length must be at least eight alphanumeric
characters. The password is case sensitive. When you change a password, a prompt asks for the old password. If
Note: You cannot delete the admin user. There is only one user allowed with read/write privileges. You
can configure up to five read-only users on the system.
Note: The is not case sensitive when you add and delete users, and when the user logs
in. However, when you use the to set the user password, authentication, or encryption, you
must enter the in the same case you used when you added the user. To see the case of
the , enter the show users command.
Format users name
Mode Global Config
Format no users name
Mode Global Config
Note: You cannot delete the “admin” user account.
Format users name unlock
Mode Global Config