Kontron AT8404 CLI - Manual (Page 297)

AT8404 Management Commands
Page 5 - 21 AT8404 CLI Reference Manual
5.8.1 snmp-server
This command sets the name and the physical location of the switch, and the organization responsible for the
network. The range for , and is from 1 to 31 alphanumeric characters.
5.8.2 snmp-server community
This command adds (and names) a new SNMP community. A community is a name associated with the
switch and with a set of SNMP managers that manage it with a specified privileged level. The length of can
be up to 16 case-sensitive characters.
5.8.2.1 no snmp-server community
This command removes this community name from the table. The is the community name to be deleted.
5.8.3 snmp-server community ipaddr
This command sets a client IP address for an SNMP community. The address is the associated community SNMP
packet sending address and is used along with the client IP mask value to denote a range of IP addresses from
which SNMP clients may use that community to access the device. A value of 0.0.0.0 allows access from any IP
address. Otherwise, this value is ANDed with the mask to determine the range of allowed client IP addresses. The
name is the applicable community name.
5.8.3.1 no snmp-server community ipaddr
This command sets a client IP address for an SNMP community to 0.0.0.0. The name is the applicable community
name.
Default none
Format snmp-server {sysname | location | contact }
Mode Global Config
Note: Community names in the SNMP Community Table must be unique. When making multiple entries
using the same community name, the first entry is kept and processed and all duplicate entries are
ignored.
Default • Public and private, which you can rename.
• Default values for the remaining four community names are blank.
Format snmp-server community
Mode Global Config
Format no snmp-server community
Mode Global Config
Default 0.0.0.0
Format snmp-server community ipaddr
Mode Global Config
Format no snmp-server community ipaddr
Mode Global Config