Kontron AT8404 CLI - Manual (Page 185)

AT8404 Quality of Service (QoS) Commands
Page 3 - 11 AT8404 CLI Reference Manual
mplsmcast, mplsucast, netbios, novell, pppoe, rarp or as a custom ethertype value in the range of 0x0600-
0xFFFF.
3.3.4 match any
This command adds to the specified class definition a match condition whereby all packets are considered to belong
to the class.
3.3.5 match class-map
This command adds to the specified class definition the set of match conditions defined for another class. The
is the name of an existing DiffServ class whose match conditions are being referenced by the
specified class definition.
Note: This command is not available on the Broadcom 5630x platform.
Format match ethertype { | custom <0x0600-0xFFFF>}
Mode Class-Map Config
Ipv6-Class-Map Config
Default none
Format match any
Mode Class-Map Config
Ipv6-Class-Map Config
Default none
Format match class-map
Mode Class-Map Config
Ipv6-Class-Map Config
Note:
• The parameters and can not be the same.
• Only one other class may be referenced by a class.
• Any attempts to delete the class while the class is still referenced by any map-name> fails.
• The combined match criteria of and must be an allowed
combination based on the class type.
• Any subsequent changes to the class match criteria must maintain this validity, or
the change attempt fails.
• The total number of class rules formed by the complete reference class chain (including both
predecessor and successor classes) must not exceed a platform-specific maximum. In some cases,
each removal of a refclass rule reduces the maximum number of available rules in the class definition
by one.