Kontron AT8404 CLI - Manual (Page 249)

AT8404 Utility Commands
Page 4 - 35 AT8404 CLI Reference Manual
4.7.10 show sntp server
This command is used to display SNTP server settings and configured servers.
For each configured server:
4.8 DHCP Server Commands
This section describes the commands you to configure the DHCP server settings for the switch. DHCP uses UDP
as its transport protocol and supports a number of features that facilitate in administration address allocations.
4.8.1 ip dhcp pool
This command configures a DHCP address pool name on a DHCP server and enters DHCP pool configuration
mode.
Format show sntp server
Mode Privileged EXEC
Term Definition
Server IP Address /
Hostname
IP address or hostname of configured SNTP Server.
Server Type Address Type of Server.
Server Stratum Claimed stratum of the server for the last received valid packet.
Server Reference
ID
Reference clock identifier of the server for the last received valid packet.
Server Mode SNTP Server mode.
Server Maximum
Entries
Total number of SNTP Servers allowed.
Server Current
Entries
Total number of SNTP configured.
Term Definition
IP Address /
Hostname
IP address or hostname of configured SNTP Server.
Address Type Address Type of configured SNTP server.
Priority IP priority type of the configured server.
Version SNTP Version number of the server. The protocol version used to query the server in unicast
mode.
Port Server Port Number.
Last Attempt Time Last server attempt time for the specified server.
Last Update Status Last server attempt status for the server.
Total Unicast
Requests
Number of requests to the server.
Failed Unicast
Requests
Number of failed requests from server.
Default none
Format ip dhcp pool
Mode Global Config